GE D20MX, Instruction Manual

Page: 124 / 168

124 GE INFORMATION D20MX INSTRUCTION MANUAL
APPENDIX D: USING CONFIGPRO WITH D20MX
3.5. Manually set the D20MX processor card.
Note : In the same device properties, the General tab does not include a D20MX
processor card.
3.5.1. Manually set the memory model in the D20MX device being modified by
selecting the Processor tab > Memory Model tab > Set Manually option.
Use the memory model settings from the factory default configuration as
a reference, See the table below.
NOTE
Step 3.6 is applicable if the device configuration were a “LAN-based Device”
configuration. LAN-based device in the device properties must first be selected under
the main General tab. It is impossible to have a LAN-based device unless the project
itself is a LAN-based project with all network addresses and settings clearly defined
for LAN A and optionally B. Step 3.6 assumes that the reader is familiar with the
complete ConfigPro LAN settings configuration steps and that these steps have
already been considered. It points out the D20MX factory default LAN-settings.
3.6.
Set the LAN Settings.
Default LAN-Based Important Settings : Notice that the D20MX factory
default configurations are LAN-based. This is because the hardware of the
D20MX RTU has built-in LAN functionality by default. Subsequently, no extra
Media Interface Card or EME card is needed.
D20MX Processor Memory Model - Set Manually
EPROM Base
60000000 [HEX] EPROM Size 10000000 [HEX]
NVRAM Base 50010000 [HEX] NVRAM Size 00FF0000 [HEX]
RAM Base 00000000 [HEX] RAM Size 40000000 [HEX]
No D20MX card
choice from this list
Need to set a man-
ual memory map