CyberDome Series Installation Manual
Appendix C: 8-inch Pendant-mount Housing Installation
49
A06-8SG0/B/April2006/1033921C
Method 2: Wall Bracket Installation
The CyberDome can be mounted using the KTA-02-12 Wall Bracket, which supports the
dome and provides a path for the video, 24VAC, and RS422 control cables. The wall bracket is
designed to mount against a hard surface, but will also mate with a KTA-25/KTA-25W Corner-
mount Bracket, a KTA-26/KTA-26W Pole-mount Bracket, or a KTA-27/KTA-27W Roof-mount
Bracket. For instructions on installing the corner-, pole- or roof-mount brackets, refer to
Ap-
pendix A: Accessory Installation
. A
3
⁄
8
in. nut driver and Phillips screw driver are required for
installation. Proceed with the following steps.
CAUTION!
DO NOT provide power to the housing until all installation steps are complete.
Step 1)
Loosen the two screws that hold the bracket’s cover, lift the cover and remove.
See
Figure 69
.
Step 5)
Feed the video, 24VAC, and
RS422 control cables through
the cable entry hole.
CAUTION!
For safety, use the appropriate fasteners for the
surface that the bracket is being mounted to
that will support a 35 lb (15.88 kg) load.
Step 6)
Securely mount the bracket to
the wall. See
Figure 70
.
Step 2)
Place the bracket’s mounting plate against the wall and mark the location of the
four mounting holes and the cable entry hole.
Step 3)
Prepare the four mounting holes in accordance with the type of wall (e.g., con-
crete, wood) and fasteners used.
Step 4)
Drill a
3
⁄
4
in. (1.91 cm) hole in the wall for cable entry. For installations that do not
allow cable entry from the wall, a
1
⁄
2
in. (1.27 cm) hole knockout is provided on
the bottom of the bracket (see
Figure 69
).
Figure 70: KTA-02-12 Minimum Load Require-
ment
Mounting Plate
Figure 69: KTA-02-12 Wall Bracket