CyberDome Series Installation Manual
Appendix C: 8-inch Pendant-mount Housing Installation
47
A06-8SG0/B/April2006/1033921C
Step 1)
Securely mount the pipe from
which the pendant housing will
be suspended. Remember
that the pipe must be able to
support a 35 lb (15.88 kg)
load.
Step 2)
Feed the video, 24VAC, and
RS422 control cables through
the pipe.
CAUTION!
If the power and RS422 cables are reversed
in step 3 (below), the CyberDome will be dam-
aged.
Step 3)
Make the cable connections
to the interface module (see
Figure 23).
Allow approxi-
mately 3” (7.62 cm) of cable
for connection.
If installing a weatherproof
housing with a heater/fan
E Option, also connect the
heater’s power cable to the
2-pin Molex connector on the
interface connector card.
APPENDIX C: 8-INCH PENDANT HOUSING INSTALLATION
The pendant housing can be mounted using one of two methods:
•
Method 1 – Suspended from a 1.25 in. pipe
(page 47)
•
Method 2 – Attached to a KTA-02-12 Wall Bracket
(page
49)
Method 1: Pipe Installation
The pendant housing contains a 1.25 in. NPT pipe flange for pipe mounting.
Adhere to the following pipe requirements:
•
Use only Schedule 40 pipe.
•
The pipe must be at least 5 in. (12.7 cm) in length to allow for wire connections.
•
The pipe must be reamed inside at the CyberDome end.
•
The pipe must be able to support a 35 lb (15.88 kg) load.
•
For outdoor applications (W option), thread sealer must be applied to the pipe to assure
that no water enters the housing.
To install the pendant housing, proceed with the following steps:
CAUTION!
DO NOT provide power to the housing until all installation steps are complete.
Figure 66: Preliminary Cable Connections