CyberDome Series Installation Manual
Housing Installation
27
A06-8SG0/B/April2006/1033921C
Step 6)
Bring the housing near the end of the pipe and insert the CyberDome’s intercon-
nect cable into the RJ45 jack on the interface module. See
Figure 39
.
Step 7)
If installing the optional heater/fan (E option), also connect the heater’s power
cable to the 2-pin Molex connector on the module. See
Figure 39
.
The fan assembly is attached separately inside the housing to the PTZ assem-
bly. Refer to
E Option (Heater/Fan)
in
Appendix A
.
Step 8)
Push the cables and interface
module back into the pipe.
Step 9)
Before threading the housing
onto the pipe, rotate it five turns
in the counterclockwise direction
(as viewed from below) to allow
for cable twist. Turn the housing
onto the pipe in a clockwise di-
rection until it is tightened se-
curely. See
Figure 41
. Check to
be certain that it is not cross
threaded.
Step 10)
Slide the rubber boot down the
pipe and fit it securely over the
housing’s flange.
Step 11)
Proceed to
RS422 Termination
on page 31.
Figure 41: Threading the Housing