Programming Site Data
1-35
February 2009
Entering a Calibration
Factor (cont.)
6.
Press
[ENTER]
to open the table (similar to Figure 1-33 below).
Figure 1-33: KFactor Table
7.
Use the four arrow keys to move to the desired entry in the table.
8.
Use the numeric keys to enter the desired value for the data
source, and press
[ENTER]
to confirm the entry.
9.
Press the [
X
] key to move to the KFactor column. Use the
numeric keys to enter the desired value, and press
[ENTER]
to
confirm the entry.
10.
Repeat steps 7, 8 and 9 for the remainder of the table.
11.
When you have completed entering values, press
[F3]
(OK) to
confirm the table and return to the Correction Factors window.
You have completed entering data for correction factors.
•
To confirm the entries and return to Operate mode, press
[F3]
(OK).
The CTF878 returns to Operate Mode.
•
To leave the window without confirming the entries, press
[F2]
(Cancel) or the
[ESC]
key. The CTF878 returns to Operate Mode.
To aid in following the programming instructions, a complete menu
map of the
User Program
is included in Figure 1-34 on page 1-37,
Figure 1-35 on page 1-38 and Figure 1-36 on page 1-39.
OK
Cancel
Data Source
KFactor
5
4
3
2
1
0
Edit KFactor Table
Summary of Contents for CTF878
