GE B90 UR Series, Instruction Manual

Page: 149 / 478

GE Multilin B90 Low Impedance Bus Differential System 5-35
5 SETTINGS 5.2 PRODUCT SETUP
5
The minimum value for all quantities is 0; the maximum values are as follows:
• phase current: 46

phase CT primary setting
• neutral current: 46

ground CT primary setting
• voltage: 275

VT ratio setting
• power (real, reactive, and apparent): 46

phase CT primary setting

275

VT ratio setting
• frequency: 90 Hz
• power factor: 2
The GGIO1 status configuration points are shown below:
PATH: SETTINGS

PRODUCT SETUP

COMMUNICATIONS

IEC 61850 PROTOCOL

GGIO1 STATUS CONFIGURATION
The
NUMBER OF STATUS POINTS IN GGIO1
setting specifies the number of “Ind” (single point status indications) that are
instantiated in the GGIO1 logical node. Changes to the
NUMBER OF STATUS POINTS IN GGIO1
setting will not take effect until
the B90 is restarted.
The GGIO2 control configuration points are shown below:
PATH: SETTINGS

PRODUCT SETUP

COMMUNICATIONS

IEC 61850 PROTOCOL

GGIO2 CONTROL CONFIGURATION

GGIO2 CF SPSCO 1(64)
The GGIO2 control configuration settings are used to set the control model for each input. The available choices are “0”
(status only), “1” (direct control), and “2” (SBO with normal security). The GGIO2 control points are used to control the B90
virtual inputs.

GGIO1 STATUS

CONFIGURATION
NUMBER OF STATUS
POINTS IN GGIO1: 8
Range: 8 to 128 in steps of 8
MESSAGE
GGIO1 INDICATION 1
Off
Range: FlexLogic operand
MESSAGE
GGIO1 INDICATION 2
Off
Range: FlexLogic operand
MESSAGE
GGIO1 INDICATION 3
Off
Range: FlexLogic operand

MESSAGE
GGIO1 INDICATION 128
Off
Range: FlexLogic operand

GGIO2 CF SPCSO 1

GGIO2 CF SPCSO 1
CTLMODEL: 1
Range: 0, 1, or 2