CamPlus 2 Plastic Dome IP Camera
Installation Manual
6
Figure 3
shows the components on the mounting side of the camera and the camera mount bracket.
Figure 3. Operating controls and their functions
Mounting side
Mounting side components include:
External I/O terminals.
Connect an external device to these terminals. See
Connections
on page 15.
Power cord terminals.
Connect the power cord from a 12 VDC or 24 VAC power supply. See
Connections
on page 15.
Initial set button.
Use this button to reset the camera to the default settings. Turn off the power to the
camera. Then turn on the power to the camera while holding this button down and wait about five seconds
without releasing the button. Wait about 30 seconds after releasing the button. The camera will restart and
the settings including the network and the date/time will be initialized.
Network connector.
Connect a CAT5 LAN cable to this connector. See
Connections
on page 15.
External I/O
terminals
Power cord
terminals
Initial set
button
Safety wire
holder
Network
connector
Camera mount
bracket
Safety wire