GCE proFIT, Instructions For Use Manual

Page: 14 / 222

14/222
GB
4.8. manually guided cutting
gCE proFIT
®
can be guided manually by the operator for free pattern cut over the outer line of the
pattern to be cut. castor wheel is to be adjusted
free for all directions and all of the three wheels
should be in contact with the panel. see also
Figure 10.
4.9. PREPaRInG oF THE METaL
sheet edges before welding
– bevel cutting with one torch (without weld root
face creation). prepare gCE proFIT
®
according to
point 4.5. above. Lose a bit the cutting angle
hand-wheel and turn the torch with the torch
holder to get requested angle. then tighten
properly again cutting angle hand-wheel. proceed
according to point 4.5. afterwards
4.10. cutting with two ToRCHES
In case the gCE proFIT
®
machine is equipped for
only one torch cutting operation, it is necessary to
mount Extension kit with second torch (part
number 304605904) first (see Fig. 11).
Please follow the steps:
1. dismount gas manifold for one torch from
the machine body and hoses from the
manifold.
2. Remove torch holder with torch from
distance adjustment bar and take the bar
from the machine.
3. Install second heat shield (6) at the
second side of the machine, opposite to
existing heat shield using distance
washer (7), imbus screw M6x20, washer
and spring washer (8, 9,10).
4. Mount gas manifold for two torches (1) on
the machine body.
5. put distance adjustment bar for two
torches into the machine.
6. Install both torch holders with cutting
torches at the distance adjustment bar.
7. Connect both torches and gas manifold
Fig.11: Extension kit with second cutting torch
with proper gas
hoses.
8. use proper cutting nozzles according to point 2.5 above. gcE proFit ® machine with two
torches can be used for bevel cutting and for strip cutting as shown at the Figure 12.
Fig.10: Manually guided cutting