GCE proFIT, Instructions For Use Manual

Page: 16 / 222

16/222
GB
•
lubricate the engine connection parts, gears and clutch with a
molybdenum-disulphide based lubricant as a precaution.
•
reinstall body lids without compression any cables. connect
clutch lever.
•
Lubricate front and rear wheel bearings components.
•
Check if machine works properly and check gas tightness before
starting operating gCE proFIT
®
.
voltage changing
a proper transformer for 240v and 110v aC is installed within the
machine. the machine
is set for the voltage specified on the
identification label placed on the body of the machine. Following this
instruction to change the voltage of the machine:
•
dismount clutch lever and screws and separate upper part of the
machine body from the lower part.
•
Change the position of electric cable from the switch panel as
shown in Figure 13.
•
Mount the upper and lower lids of the body together after closing
them.
•
Change the voltage marking on the identification labels.
when separating the upper and lower parts of the body, make
sure that motor cables are not stretched.
note: it is useful to mark on the identification shield the new voltage
value after changing . connecting machine to a wrong voltage can
lead to failures or caused dangerous conditions for the operator.
ELECTRICaL DIaGRaM
6.
Fig.13: Changing of the voltage
240V-110 V
110 v
v 240
7.
TRoUBLE SHooTInG 8.
v Control panel 240
110 v Control panel