32
BE24G
UK
15 - PAUSE TIME LEARNING
Meaning
Signal
Effect
Photo 2 intercepted in stand-by
in presence of START command
Edge intercepted in stand-by
in presence of START command
Edge intercepted in pause in presence of
START command or at the closing beginning
Low Battery before closing (21V).
Low Battery before opening or closing(16V).
5 fast flashings
3 slow flashings
3 slow flashings
4 slow flashing
4 slow flashing
When released it opens
Blocked closed door
Blocked open door
Blocked door
Blocked open door
Opening
Closing
0,8s ON, 0,8s OFF continuous
0,4s ON, 0,4s OFF continuous
The gate is opening
The gate is closing
16 - FLASHING LIGHT SIGNALS SUMMARY
Pause time pre-cycle learning
Pause time learning
steady on
slow flashes every second
Closed blocked door
Closed blocked door
WARNINGS
• Values loaded by default:
- Total automatic reclosing time: 20 s;
- Pedestrian automatic reclosing time: 10 s;
• Be sure that the control unit has already successfully stored a stroke learning.
• Be sure that the gate has finished the closing manoeuvre before making the learning procedure.
• The time learning of total and pedestrian automatic reclosing time needs 2 different procedures.
Learning procedure of Total Pause Time
• Put DIP2_7 in ON.
• The FLASHING LIGHT glows steadily.
• Push START to start the pause time counting.
• The FLASHING LIGHT makes short flashes every second.
• Once passed the pause time chosen (MAX 127 s), give a new START command.
• The FLASHING LIGHT glows steadily to show the successful operation.
• Put DIP2_7 in OFF.
Learning procedure of Pedestrian Pause Time
• Put DIP2_7 in ON.
• The FLASHING LIGHT glows steadily.
• Push PED to start the pause time counting.
• The FLASHING LIGHT makes short flashes every second.
• Once passed the pause time chosen (MAX 127 s), give a new PED command.
• The FLASHING LIGHT glows steadily to show the successful operation.
• Put DIP2_7 in OFF.
33
BE24G
UK
The gate does not move after a START
command.
Ÿ
Check that L3, L4 and L5 are off; if not, check the devices connected to
terminals 19-20-21.
Ÿ
Check fuses.
Ÿ
Check that the battery voltage is not below 22VDC.
Ÿ
If L8 is blinking fast, learning procedure must be executed.
Transmitter range is short.
Check terminals 26-27 screws are tight.
Check and replace transmitter battery.
The gate does not fully open/close.
Check the motor and encoder connections.
The gate moves slowly.
Check the control board is not running on battery.
The gate moves slowly during opening.
The first maneuvre after a power failer is slowed and with automatic logic.
17 - TROUBLESHOOTING
Summary of Contents for BE24G
Page 59: ...59 BE24G NOTES...
