![background image](http://html1.mh-extra.com/html/gbc/titan-110/titan-110_operation-and-maintenance-manual_3898577068.webp)
Operations
Page 5 - 11
Titan 110/ 165 Operation and Maintenance Manual
© GBC Films Group November 2000
To replace the feed table
a) Align the front of the feed table with the
front feed table support pegs.
Front feed table
support peg
b) Pull the feed table safety pin. Set the rear of
the table down on the rear table support
bar.
Rear feed table support bar
c) Replace the pressure plate if needed and
lower the safety shield to its fully closed
position.
5.6 Film loading
The Titan 110/ 165 can accommodate Poly-
In or Poly-Out films. Each film requires a different
loading procedure. Refer to Section 6 Applications
for webbing methods. With regards to webbing
methods, both require the adhesive side of the film to
face away from the heating components.
W A R N I N G
Extreme caution should always be exercised
when removing an unwind shaft, the
gripper tabs can cut you!
Upper unwind
a) Lift the upper unwind shaft up from the shaft
saddle.