Operations
Page 5 - 9
Titan 110/ 165 Operation and Maintenance Manual
© GBC Films Group November 2000
5.4 Pressure plate
INFORMATION
Locator pins on the pressure plate are
not associated with an interlock switch.
The laminator can operate without
the pressure plate installed.
The pressure plate assists in keeping the leading
edge and the trailing edge of the print flat when fed
into the laminator. The pressure plate may be installed
or removed depending on operator preference.
To remove the pressure plate
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
a) Raise the safety shield.
b) Pull on the locator pins on the right and left
sides of the pressure plate and lift out
Locator pin
To replace the pressure plate
a) Pull on the locator pins on the right and left
sides of the pressure plate and position with
the pressure plate locator holes on the
laminator.
Locator pin
b) Lower the safety shield to its fully closed
position.
