![background image](http://html1.mh-extra.com/html/gbc/titan-110/titan-110_operation-and-maintenance-manual_3898577013.webp)
Page 1 - 2
Safety
Titan 110/ 165 Operation and Maintenance Manual
© GBC Films Group November 2000
1.2 Safety features
The Titan 110/ 165 laminator has been
designed with safety as a primary consideration;
however, you must become thoroughly familiar with
the controls, proper operation, proper service
procedures and safety features of the laminator before
using or servicing the unit.
In addition, the heating components of the
Titan 110/ 165 can reach temperatures of over 200
o
F
( 100
o
C ).
D A N G E R
At these temperatures there is a danger of
severe burn if the rolls are touched during
setup, operation or servicing.
INFORMATION
Only a qualified service technician should
perform any procedure requiring the
cabinet doors to be opened.
The word qualified is defined as;
Qualified ;
• Any engineer that has experience with
electrical and mechanical design of lamination
equipment. The engineers should be fully aware of
all aspects of safety with regards to lamination
equipment.
• Any commissioning or service engineer must
be of competent nature, trained and qualified to GBC
Films Group standards to fulfill that job. This person
will have completed and passed the full service
training course from GBC Films Group.
• Any GBC Technician, GBC Specialist, and /
or GBC Films Group Technician that has been through
the GBC Pro-Tech service training course.
An important feature of the Titan 110/ 165
laminator are the safety latches and the interlocks. The
front safety shield (Figure 1.2.1) and the feed table
(Figure 1.2.2) are both equipped with safety latches.
When a safety latch is not in the locked position, the
motor is disabled.
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G