Page 1 - 10
Safety
Titan 110/ 165 Operation and Maintenance Manual
© GBC Films Group November 2000
D A N G E R
At no time should you attempt to over ride
any of the safety latches on the laminator.
INFORMATION
All E-STOPS must be unlatched, safety
shield fully closed and feed table properly
installed before operating.
INFORMATION
Locator pins on the pressure plate are
not associated with an interlock switch.
The laminator can operate without
the pressure plate installed.
W A R N I N G
Extreme caution should always be exercised
when removing an unwind shaft, the
gripper tabs can cut you!
W A R N I N G
Extreme caution should always be exercised
working around the 3 inch core grippers,
the gripper tabs can cut you!
Ensure the roll of laminate is loaded
properly on the unwind shaft.
Exposed adhesive should be facing
away from the heated components.
This will prevent hours of cleaning!
CAUTION
INFORMATION
For core grippers, turning the roll film in
the same direction as the gripper tabs while
sliding makes loading the film onto
the unwind shaft easier.
W A R N I N G
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
Y o u c a n b e C R U S H E D o r B U R N E D !
