![background image](http://html1.mh-extra.com/html/gbc/talon-44-ce/talon-44-ce_installation-and-operation-manual_4077073007.webp)
Operations Manual
Page 7
T
ALON
44/64
CE
©2004 General Binding Corporation
Important Safeguards
WARNING: TO GUARD AGAINST INJURY, THE
FOLLOWING SAFETY PRECAUTIONS MUST BE
OBSERVED IN THE INSTALLATION AND USE
OF THE LAMINATOR.
General
Keep hands, long hair, loose clothing, and articles such as
necklaces or ties away from the front of the heat and pull
rollers to avoid entanglement and entrapment.
The heat rollers can reach temperatures over 300˚F (150°C).
Avoid contact with the heat rollers during operation or shortly
after power has been removed from the laminator.
Keep hands and fingers away from the path of the sharp
film cutter blade located at the film exit.
Do not use the laminator for other than its intended
purpose.
Avoid moving the laminator on uneven floor surfaces. Never
tilt the laminator.
Do not defeat or remove electrical and mechanical safety
equipment such as interlocks, shields and guards.
Do not insert objects unsuitable for lamination or expose
the equipment to liquids.
Electrical
The laminator should be connected only to a source of power
as indicated in these instructions and on the serial plate
located on the rear of the laminator. Contact an electrician
should the attachment plug provided with the laminator not
match the receptacles at your location.
CAUTION:
The receptacle must be located near
the equipment and easily accessible.
Do not operate the laminator with a damaged power supply
cord or attachment plug, upon occurrence of a malfunction,
or after the laminator has been damaged. Contact GBC’s
Technical Service Department or your dealer/distributor
for assistance.
Service
Perform only the routine maintenance procedures referred
to in these instructions.
WARNING:
Do not attempt to service or repair
the laminator.
Disconnect the plug from the receptacle and contact GBC’s
Technical Department or your dealer/distributor when one
or more of the following has occurred.
- The power supply cord or attachment plug is
damaged.
- Liquid has been spilled into the laminator.
- The laminator is malfunctioning after being mishan-
dled.
- The laminator does not operate as described in these
instructions.
Summary of Contents for Talon 44 CE
