Operations Manual
Page 27
T
ALON
44/64
CE
©2004 General Binding Corporation
Fig 30
Threading Card Procedure
This procedure describes how to feed two loaded films
through the main rollers (Figure 30).
1.
At this point you should have an upper roll of film and
lower roller roll of film loaded onto the laminator with
the appropriate material for your application.
2.
The table and safety shield must be properly
installed.
3.
Push the threading card into the main roller nip. The
threading card becomes sandwiched between the
upper and lower loaded films.
4.
Set the roller handle to a laminating position, press
the
RUN
button.
5.
Once the threading card has exited the laminator,
press the
STOP
button.
6.
Use the rear slitter to cut the threading card from the
web.
7.
If you are not running the laminator, set the roller
handle to the
“RELEASE”
position.
8.
Now refer to the section entitled
START LAMI-
NATING.
Summary of Contents for Talon 44 CE
