Page 7 - 3
Troubleshooting
F 60 C Operation and Maintenance Manual
© April 2001 General Binding Corporation
7.2 Film problems
The following is a list of common film problems
you may encounter. For definitions of terminologies, please
refer to 7.4 Glossary of terminology.
Pressure sensitive
Problem : Silvering in the laminate
Hints : • Allow the print to cure ( 24 hours )
• Increase pressure to laminating rolls
Problem : Tunneling
Hints : • Print should be wound image side out.
• Do not roll tightly
• Do not roll at all.
Problem: Delamination
Hints: • Check operating pressures
• Check operating speed
• Laminate compatibility with ink
• Ink compatibility with paper
Mounting
Problem : Image creases when mounting
Hints : • Press down on leading edge from center
outwards.
• Be sure image is conformed to the roll
• Use a speed you are comfortable with
• Be sure even tension is supplied to the image
7.3 Machine problems
Once the Hints are all checked, and your problem
still exists, a service call must be placed for a qualified
service personnel to fix the problem.
You may do this by dialing 1 ( 800 ) 790 - 7787.
This will connect you with GBC National Service dispatch.
You will be required to give the serial number of your
machine when placing a service call.
A space below has been provided to keep this
number readily available if and when needed.
My Falcon 60 C Laminator serial # is :
At no time does GBC Films Group suggest or
recommend that you attempt to fix the machine by
removing the cabinets covers yourself.
W A R N IN G
D o n ot w ear ties, loose fit cloth in g or
d an glin g jew elry w h ile op eratin g or
servicin g th e lam in ator. T h ese item s can get
cau gh t in th e n ip an d ch o k e yo u or you can
b e cru sh ed or b u rn ed .
