![background image](http://html1.mh-extra.com/html/gbc/advancedpunch/advancedpunch_technical-and-service-manual_571056068.webp)
Section 4
4-10
© Copyright 2009 GBC. All rights reserved.
Advanced Punch Service Manual
5. From the side of the punch, slide the shaft towards the end of the shaft [1]
without the E-Ring [2] until the other end of the shaft clears the nylon bushing
and bracket.
6. Lift the opposite end of the shaft [3] and slide it out of the Bypass panel in the
opposite direction of the removed E-Ring [4].
Installation Note:
Make sure the nylon bushing is installed so that it protrudes
through the mounting bracket of the rear frame into the Bypass panel [5].
Figure 4.11 Bypass Panel, Shaft, and Rear Frame.
[5]
[2]
[5]
[4]
[1]
[3]
Summary of Contents for AdvancedPunch
