GBC 2064
Operation Manual
© 2006 General Binding Corporation
Page 14
SEQUENCE OF OPERATIONS Diagram #1
GBC U.S &CE 3064WF
Effect of Fiber Optics on sequence of operation
Modes
Situation 1
Situation 2
Situation 3
Machine Run Mode
Normal operation
(
No Interruption to any
safety circuitry & Fiber
optic beam)
High speed.
Interrupted fiber optic
beam or opened any
safety circuitry.
Fiber optic beam c all safety
circuitries are closed
Control panel:
Forward Speed
: Zero to
Max.
Press Run push button
to switch over from foot
switch to the control
panel.
Machine stops Instantly.
Use foot pedal to override
@ 3f/m.
Machine will remain stationary until
run switch is pressed.
Push RUN button switch to run machine
again (Normal operation) mode.
Forward Mode
Press push button
forward switch
Foot switch:
Forward Speed
: Zero to
Max.
Note:
Press foot pedal
to change mode and
take over from control
panel at preset speed.
Machine Runs @
3f/m.
(Automatic override from
high to low voltage)
Machine still remains at low voltage
speed of 3f/m.
Steps required to run at (various speed):
The operator will have two choices,
Choice A:
1. Release foot pedal to stop machine.
2. Press foot pedal again to start
machine at original preset control panel
knob speed (pot).
Choice B:
1. Press and hold Run push button
switch on the control panel while foot is
still on pedal.
2. Release foot pedal.
3. Adjust speed using speed knob
Reverse speed
:
Zero to
Max.
Press Run push button
to switch over from Foot
switch to the Control
panel.
Machine stops Instantly.
Use Foot pedal to
override @ 3f/m.
Machine must not run. It will remain
stationary.
Push RUN button switch to run machine
again at Normal operation mode.
Reverse Mode
Press Reverse
Push button switch.
Reverse speed
:
Zero to
Max.
Note:
Press foot pedal
to change mode and
take over from control
panel.
Machine Runs @ 3f/m.
(Automatic override from
high to low voltage)
Machine still remains at low voltage
speed of 3f/m.
Steps required to run at (various speed):
The operator will have two choices,
Choice A:
1. Release foot pedal to stop machine.
2. Press foot pedal again to start
machine at original preset control panel
knob speed (pot).
Choice B:
1. Press and hold Run push button
switch on the control panel while foot is
still on pedal.
2. Release foot pedal.
3. Adjust speed using speed knob
