GBC 2064
Operation Manual
© 2006 General Binding Corporation
Page 9
FEATURES/ACCESORIES GUIDE
Refer to the following pages for detailed information on the above Features
FEATURES/ACCESORIES GUIDE (DETAILED DESCRIPTION)
Media Tables:
(Fig. 2 & 3)
On both the Front Media & Rear Media
tables, the safety interlock switch will not
allow the Laminator to operate at full speed
unless the tables are properly installed.
The Media tables are used to position items
for Lamination. There are two media tables
on the machine one on the front & one on the
rear of the Laminator. The Front Media table
incorporates an Idler on the leading edge of
the table. This is used for roll to roll
applications during lamination
Note:
The Laminator will operate only when the
Media Table and Media Table Latch are
Properly Installed.
The Features/Accessories Include:
A. Pressure Plate:
(Fig. 2A) Used for
guiding stock and ensuring a wrinkle free
feed into the roller
B. Feed Roller Idler:
(Fig. 2B) Used for
guiding Media through the laminator. The
table Idler is helpful in roll to roll operation
and helps move large ridged panels through
the nip.
C. Front Table:
(Fig. 2C) Used to guide and
support images into the nip.
D. Rewind Tube:
(Fig. 3D) Used to rewind
release liners or finished Medias.
E. Rear Table:
(Fig. 3E) Used to support
finished Media and used when running the
machine from the rear.
EMERGENCY STOP BUTTONS
(Fig. 1– Item A)
Two emergency stop buttons are available on
the Laminator on the top corners of the
Laminator.
To engage Emergency -stop button, Press any
emergency -stop safety push button to stop
the roller movement
To disengage turn the push button clockwise
after the emergency condition has been
resolved.
A
Figure 3
Figure 1
Figure2
B
C
E
D
D
