GBC 2064-WF, Instruction Manual

Page: 26 / 28

GBC 2064 Operation Manual
© 2006 General Binding Corporation Page 25
- A - - B -
- A - - B -
- A - - B -
Figure 39
Figure 40
Figure 41
Heat
The “READY” indicator may extinguish if the speed
is set too fast for the material being laminated. Either
lower the speed setting or press STOP ( ) and wait
until the “READY” indicator illuminates. Operation
of the laminator for more than thirty minutes at a
time may necessitate a lower speed setting. It is
recommended that, during periods of long runs, the
items being laminated are alternated between thick
and thin. Do not combine thick and thin items at the
same time, as this will result in
a poor edge seal around the thinner material. If you
are unsure that the laminator is set at the proper
speed for the item to be laminated, run a test piece
(scrap) of the same or similar material through the
Laminator. This procedure is recommended because
rotating the heat roller prior to lamination will more
evenly distribute the heat.
Make speed adjustments if necessary.
Output
1. “D” waves in the image (Fig. 39 A).
•
Check paper tension.
•
Paper may be damp or not dry.
2. “D” waves in the laminate (Fig. 39 B).
•
Check main roller pressure.
•
Check pull roller pressure.
3. Straight waves in output (Fig. 40 A).
•
Check operational settings for materials
being used.
•
Check clutch tension.
4. Indent waves in output after pull rollers
•
Insufficient cooling time.
•
Output was handled prior to cooling.
•
Use cooling feature if not on.
•
Machine was stopped on print.
5. Angled waves in the output
•
Main air Supply setting
•
Check main Roller Pressure.
•
Check main roller pressure.
•
Check pull roller pressure.
•
Check for Paper Tension.