GBC 2064
Operation Manual
© 2006 General Binding Corporation
Page 10
FEATURES GUIDE
F. In-Line Slitters:
(Fig. 4F)
The In-Line Slitters allows the operator to slit
images as they pass through the Main Rollers
and into the Pull rollers. The trimmed waste
can then be attached to the Rewinder Tubes
and disposed of later.
G. Cooling Fan Bridge:
(Fig.4G)
There are 3 internal Cooling Fans. The fans
can be used to cool down media while it
passes through the Main Rollers and into the
Pull Rollers.
H. Chill Bar:
(Fig.5H)
The chill bar shown in Figure 5H is in the up
position. While in the up position, the
laminate runs over the Chill Bar assisting in
eliminating waves that may occur during
some processes. When the operator chooses
not to use the chill bar, it can be returned to
the down position for storage.
I. Pull Rollers:
(Fig.5I)
The Pull rollers located at the back of the
laminator are motor driven. They
simultaneously pull the film and image.
J. Upper Tension Idler:
(Fig.5J)
The Upper Tension Idler Guides the upper
lamination onto the Top Main Roller insuring
a constant amount of wrap on the Top Main
Roller.
K. Main Rollers:
(Fig. 6K) The 2 Main
Rollers are used to apply Heat and Pressure to
films being used. Silicone rubber coated steel
tubes heat the laminating film and compresses
the heated film to the items being laminated.
Heat is provided by an internal heating
element.
L. Upper Supply Shaft:
(Fig. 6L)
The Upper Supply Shaft is used to hold film
to be used, and to apply brake tension.
M. Lower Supply Shaft:
(Fig.6M)
The Lower Supply Shaft is used to hold film
to be used, and to apply brake tension
G
F
Figure 4
H
I
Figure 5
J
K
L
M
Figure 6