![background image](http://html1.mh-extra.com/html/gaui/x7-flybarless/x7-flybarless_instruction-manual_3804311020.webp)
18
GAUI
TAI SHIH HOBBY CORPORATION
GAUI
TAI SHIH HOBBY CORPORATION
N3x5.5L_________
3
M3x10__________
1
M3x16__________
2
M3x25__________
1
M3x25
M3x16
N3x5.5L
N3x5.5L
M3x10
適當鎖緊M3x25螺絲。
上齒盤輪穀含單向鋼套
主齒盤輪穀
100T主齒盤
66T上齒盤
垂直尾翼
M3x6___________
6
M3x8___________
6
W16.5x19x0.2____
2
M3x6
M3x8
W16.5x19x0.2
S扣環
垂直尾翼組裝
主齒盤組裝
螺絲均需上止滑劑
All Screws should
be applied with thread lock.
請注意:非常重要
使用圓棒將單向軸承油,完全擠壓入針腳隙縫內,
使單向軸承完全填滿單向軸承油。
ATTENTION: Very Important!
Use a stick as a tool, squeeze the grease into the
bearing, make sure the needles of the one-way
bearing is completely surrounded with grease.
Tail vertical stabilizer
66T crown gear
Crown gear hub with one way sleeve
100T main gear
Main gear hub
C-clips
Fix it with M3x25 screw.
Tail Gear Case Assembly
Main Gear Assembly
請注意: 當主旋翼轉速低於2300rpm 時,建議使用105mm尾旋翼。
當主旋翼轉速高於2300rpm 時,建議使用95mm尾旋翼
Notice: When head speed is below 2300rpm, use 105mm tail blades.
When head speed is above 2300rpm, use 95mm tail blades.
將N3x5.5L螺母放入尾旋翼夾頭凹槽內
再鎖上M3x16螺絲。
Put the N3x5.5L nylon lock nut inside
the aligning hole, then fi x the M3x16
screw.
螺絲墊片
Countersunk Washer