GA-600S 3D Wheel Aligner User Manual
iv
Obligation by the operator to be considerate and avoid negligent
acts:
The equipment was designed and constructed with consideration to required
harmonized standards, as well as additional technical specifications. It therefore
corresponds with the current state of technology and provides the maximum
standard in safety during the operation.
The machine safety, however, can only be implemented during the operation, if all of
the required steps have been taken. The operator of the machine has the obligation
to plan these actions and check their compliance.
The operator must specifically verify that:
The machine is only used according to specifications.
The machine is only operated in perfect operational condition and that the safety
equipment is routinely inspected as to their operational condition.
The necessary personal safety equipment for operating, maintenance and repair
personnel is available and being worn.
The operating instructions are always in a legible condition and are completely
available at the machine location.
The machine is only operated, maintained and repaired by qualified and authorized
personnel.
This personnel is instructed routinely in all pertaining questions of work safety and
environmental protection, and knows the operating instructions, especially the
safety instructions contained therein.
All safety and warning labels attached to the machine are not removed and are
legible.
3 Concrete safety instructions and applied symbols
Concrete safety instructions are provided in the following operating instructions
which will point out any unavoidable remaining risks during the machine operation.
These remaining risks contain hazards for:
Persons
Product and machine
The environment
