GA-600S
3D Wheel Aligner User Manual
4-4
4
．
Push the vehicle back and forward as instructed by the screen.
Caution
1. Before push compensation, the steering wheel shall be well locked,
otherwise, the wheel will not be stable when do push compensation, and
this will cause inaccurate result of push compensation.
2. When push vehicle back and forward, shall not block the camera view.
3. Make sure the pushing is steady and stable.
4.
The target initial position shall be vertical to the ground, otherwise, might
make the target tilting angle too big and cause error.
5. Remove passing bridge when compensation finished.
[Target red color status]
Indicate the captured image is not applicable for measurement; possible reason shall
be blockage between camera and target.
[Help Information]
Help system and tips for the current page.
[Target Monitor]
Can find out the reason in target monitor screen when system prompt target blocked.
Also can adjust the lateral beam height manually in this screen.
[Previous]
Return to the previous step to do rolling compensation again.
Figure 4. 4
The screen will display real time toe, camber of each wheel after push compensation.
