CHAPTER 12: Adding and Replacing Components
130
7
Note any jumper settings on the old drive and set the jumper on the new drive to be the
same.
8
Slide the new 3.5-inch component into the bay, then push down on the release latch to
move it to the Lock position.
9
Reconnect the cables on the 3.5-inch component, using your notes from
10
Replace the 5.25-inch component bay into the chassis.
11
Slide the 5.25-inch component into the bay and push up on the release latch to move it
to the Lock position.
12
Reconnect the cables on the 5.25-inch component, using your notes from
.
13
Replace the front bezel and the reinforcing beam/hard drive assembly, then replace the
side panel.
Replacing an expansion card
To replace an expansion card:
1
Remove the side panel by following the instructions in
.
2
Remove the bezel by following the instructions in
“Removing the front bezel” on page 124
.
3
For more stability, place your computer on its side. To avoid scratching the case, place it
on a towel or other non-abrasive surface.
4
Disconnect any cables that are attached to the card, noting their locations and orientation.
(You may need to reconnect the cables after you install the new card.)
Caution
Be careful not to pull or damage the hard drive power and data cables when
you remove the metal reinforcing beam/hard drive assembly.
Summary of Contents for 3-Bay mBTX Pro
