37
△
Note
If "0.Err" is displayed or if the flow rate does not reach
0mL/min after readjustment, the flow rate sensor or
circuit may be defective.
As repairs are required, please refer to "11.1 Repair".
[In an abnormal condition].
⑤
To make other settings continuously, press
"MODE Button" to select the desired item.
If not, press and hold the "POWER Button" to exit
the calibration mode. (The power is turned off.)
[For other settings]
Press
[To exit the calibration mode]
Press and Hold
7.6 Leak Check
Ensure that there is no air leakage inside GSP-501FT.
①
(If it is not in the calibration mode), activate the
calibration mode and make sure that "25°C tStd"
is displayed. (When the conversion temperature is
set to 20°C, "20°C tStd" is displayed.)
