Gasboy 9822Q, Installation & Operation Manual

Page: 36 / 47

GASBOY Series 9820Q
30 MDE-4339 9820Q ASTRA Installation/Operation • July 2004
Address
12
13
14
15
SW2-1
Closed
Open
Closed
Open Closed
Open
SW2-2 SW2-3
Open
Open
SW2-4
Open
Open
11
Open Closed Open Open
10
Closed Closed Open Open
9
Open Closed Closed Open
8
Closed Closed Closed Open
6
7
Closed
Open Open
Open Open
Open Closed
Closed
4
5
Closed
Open Open
Open Closed
Closed Closed
Closed
2
3
Closed
Open Closed
Closed Open
Open Closed
Closed
1 Closed
Open
Closed
Closed Closed
Closed Closed
Closed
Closed Open Open
Open Open Open 16
Open
Closed
SW1-7 Totalizers
Reset
Normal
Authorization
Yes
SW1-6
Closed Series 1000 Fuel System
TopKAT mechanical
All Non-GASBOY systems
Open No CFN
TopKAT top-mount
TopKAT electronic
No fuel system
SW1-6 Authorization
This switch allows activation of the 9820Q from some
types of fuel management systems. When the switch
is closed, a 115 VAC (230 VAC Int’l) signal must be
present on the Control Feed line for pump activation
to occur (required setting for Series 1000, TopKAT
mechanical, and all non-GASBOY systems ). When
open, the 9800 ignores the Control Feed line
(required setting for CFN, TopKAT electronic, or no
fuel system).
SW1-7 Totalizers
This switch should be set to open for normal operation. When closed, this
switch enables the reset of the electronic totalizers. See
View/Reset
Totalizers later in this section for details.
SW1-8
Not used.
SW2
This four-position switch pack serves a dual purpose: as an address setting when communicating on the GASBOY
RS-485 loop or TopKAT, or as a pulser output rate selector when pulser data is sent to a fuel management system
other than a GASBOY CFN or TopKAT.
Address Switches
A unique address identifier must be set when the 9820Q
is connected to the GASBOY RS-485 pump loop via the
9820Q RS-485 I/F PCB. Because there are 16 possible
address combinations, up to 16 units (single or twin) may
be connected to the pump loop. Addressing should start
at 1 and continue sequentially through 16. The physical
wiring order does not have to correspond with the address
order; that is the first unit on the RS-485 loop doesn't
have to be address 1. The chart at right gives the switch
settings and address selections.