GAS GAS Enduro Series, Workshop Manual

Page: 16 / 72

Workshop manual
-16-
- Position the output sprocket (2) on the secondary shaft and fit the retaining
ring (1).
- Insert the clutch rod (arrow).
- Position the hydraulic clutch clamp with a new gasket, fit the output sprocket
guard and tighten the screws (arrows).
Tightening torque: 6 Nm.
- Tense the chain.
- Fit the rear brake pedal and the rear brake pump guard.
Tightening torque: 29 Nm.
Note:
Check that the coolant pipes are not cut or damaged.
- Attach the spark plug connector (arrow) and connect the coolant pipes on both
sides of the engine.
Note:
- M
akesurethatthecoolantdrainscrewonthewaterpumpistightandhas
a new gasket.
Tightening torque: 9 Nm.
- Disconnect the coolant recirculation tube.
- Refill the coolant system through the left-hand radiator cap.
Mixture of antifreeze and distilled water: 1:1 (antifreeze 50%, distilled water 50%).
Capacity: 1.1 litres.
Note:
-Makesurethatthetransmissionoildrainplugistightandhasanewgasket.
Tightening torque: 20 Nm.
fITTING THe eNGINe TO THe fRame
1
2