Workshop manual
-15-
fITTING THe eNGINe TO THe fRame
- Fit the engine to the frame and position it correctly on the brackets.
- Align the swinging arm with the engine and frame, grease the swinging arm
shaft and fit it.
- Fasten the engine fixing screws to their brackets.
Note:
The self-locking nuts that hold the engine must be replaced with new ones.
- Lightly tighten all of the nuts and then to the specified torque:
Nuts
Tightening torque
A
60 Nm
B
25 Nm
C
60 Nm
D
80 Nm
- Fit the carburettor.
- Fit the magnetic flywheel wiring to the frame and fix correctly.
- Attach the control unit connector and the other wiring connectors.
- Fit the gear change lever.
Tightening torque: 15 Nm.
Note:
Theoutputsprocketmustbeplacedinthesamepositionfromwhereitwas
removedtoachievethesameweardirection.
A
C
D
B
Summary of Contents for Enduro Series
