GAS GAS EC 350F, Owner'S Manual

Page: 53 / 150

SERVICE WORK ON THE CHASSIS 12
51
12.8 Installing the fork legs
402556-10
Main work
–
Position the fork legs.
Bleeder screws
1
are positioned toward the front.
Info
The rebound damping is located in right fork leg REB (red
adjuster). The compression damping is located in left fork
leg
COM (white adjuster).
Grooves are milled into the side of the upper end of the fork
legs. The second milled groove (from the top) must be flush
with the upper edge of the upper triple clamp.
F03182-11
–
Tighten screws
2
.
Guideline
Screw, top triple clamp M8 20 Nm (14.8 lbf ft)
–
Tighten screws
3
.
Guideline
Screw, bottom triple
clamp M8 15 Nm (11.1 lbf ft)
F03181-10
–
Position the brake caliper, and mount and tighten screws
4
.
Guideline
Screw, front
brake caliper M8 25 Nm (18.4 lbf ft)
Loctite ® 243™
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp. Mount
and tighten screws
5
.
Guideline
Screw, brake line
bracket EJOT 1.7 Nm (1.25 lbf ft)
Finishing work
–
Install the front wheel. ( p. 90)
–
Install the headlight mask with the headlight. ( p. 101)
–
Check the headlight setting. ( p. 103)
12.9 Removing the lower triple clamp
Preparatory work
–
Remove the headlight mask with the headlight. ( p. 101)
–
Raise the motorcycle with a lift stand. ( p. 48)
–
Remove the front wheel. ( p. 89)
–
Remove the fork legs. ( p. 50)
–
Remove the front fender. ( p. 55)
–
Remove the handlebar cushion.