GAS GAS EC 350F, Owner'S Manual

Page: 111 / 150

COOLING SYSTEM 16
109
16.6 Changing the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling system components if the engine or the cooling
system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator hoses or
other components of the cooling system.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Danger of poisoning Coolant is toxic and a health hazard.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
F03254-11
Main work
–
Position the motorcycle upright.
–
Place an appropriate container under the water pump cover.
–
Remove screw
1
. Take off radiator cap
2
.
–
Completely drain the coolant.
F03255-10
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Screw, water pump
cover M6 10 Nm (7.4 lbf ft)
–
Pour coolant in up to level
A
above the radiator fins.
Guideline
10 mm (0.39 in)
Coolant 1.2 l (1.3 qt.) Coolant ( p. 137)
–
Mount radiator cap
2
.
Finishing work
–
Go for a short test ride.
–
Check the coolant level. ( p. 107)