5 - PROCEDURES
96
190-00356-00 Rev B
Vectors-To-Final Approach
4. Select “Load?” (or “Actvate?”, f already on
vectors-to-final).
To activate vectors-to-final from the procedures
page:
1. Select Bllard Muncpal (KTOP) as your dest-
naton, usng the
direct-to
key or as the last
waypont n a flght plan.
2. Press the
PROC
key and select the “VOR 22”
approach.
3. From the transtons wndow, select “LEBVY”
as the IAF. Also, select “Load?”.
4. When cleared, press the
PROC
key and select
“Actvate Vector-To-Fnal?”.
Flying the Vectors Approach
With “vectors to final” selected, the CDI needle
will remain off center until you’re established on the
final approach course. With the approach activated,
the
map page
will display an extension of the final
approach course in magenta (remember, magenta is
used to depict the active leg of the flight plan) and
“VTF” will appear as part of the active leg on the
default NAV page
(as a reminder that the approach was
activated with vectors-to-final). In this example, we’ll
assume ATC vectors result in a rectangular course to
intercept final, as follows:
DO NOT USE FOR
NAVIGATION
1.
When VTF s actvated, the 500W-seres unt
swtches from en route mode to termnal mode
and the CDI scale transtons from 2.0 to 1.0
nautcal mles, full scale deflecton.
2. If you haven’t already done so, actvate the
approach (wth vectors-to-final). Ths allows
the 400W-seres unt to gude you to the final
Summary of Contents for GNC 420AW
