Garland SHAKER 310 DPG, Instruction Manual

Page: 35 / 128

English English
35/128
6.4.4. ENGINE STOPPAGE
1. Let go of the accelerator (C) and let the engine run
at idle speed for a few seconds.
2. Stop the engine by displacing the switch from the
(A) position to the ¨O¨ position (stoppage).
6.4.5. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible
loosening or overheating of parts of the
machine. If you detect any anomalies stop
inmediatly the machine and check it carefully. In case
of failure take the machine to the repair service. In any
case you should continue working if you feel that the
performance is not correct.
Do not use the machine if it is damaged or
incorrectly regulated.
7. MACHINE USAGE
Only use this machine for those jobs for which it
has been designed. The use of this machine for other
uses is dangerous and could cause damages to the
user and/or the machine.
Do not start the machine in a closed area. The exhaust
fumes, the vapours of the petrol and oil, all contain
carbon monoxide and other dangerous chemical
substances. In case of gas concentration due to
insufficient ventilation, eliminate from the work area
everything that impedes the correct flow of air and do
not work in this area again until it is well ventilated
and the gas concentration does not happen again.
Mow only at daylight or in good artificial light. Do not
use this machine at night, with fog and with reduced
visibility. Always make sure that you can clearly see all
the working area.
Avoid operating the equipment in wet grass, where
feasible. Take special care when using this machine
in the rain or after rain because the ground is slippery
and you can slip.
If you slip or fall stop accelerating and move the
switch to “O” (Off).
Do not rely solely on the warning signs on the
machine. Be always alert.
It is neccesary to pay attention to posible loosening or
overheating of parts of the machine. If you detect any
anomalies stop inmediatly the machine and check it
carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.
Remember to always use the machine with clean
hands and without petrol and oil.
Do not allow any other person into the work area.
All other people must be at least at a distance of 15
metres as it is a dangerous area.
Never leave this machine unattended.
It is imperative that the engine is turned off when
carrying the machine from one working area to another.
Never touch elements that can be hot during the start
up or operating the machine, for example, the escape,
sparks or high voltage cables.
Do not use accessories except those recommended
by our company as otherwise the use of other non
original accessories could cause severe damages to
the end user, to passers-by and to the machine.
Always follow the safety rules stated in this manual.