![background image](http://html1.mh-extra.com/html/garland/mwe-9501/mwe-9501_operation-manual_564375013.webp)
13
The following procedures are the procedures for installing the teflon sheets on to the upper platen
on the Garland Clamshell grill. The components shown below are included with your grill when
purchansed.
1. Slide release material rod through hemmed end of the
release material sheet.
2. Hook release material rod on brackets located at the rear
of the upper platen
Upper Platen (Side View)
Release Material Hook
Release Material Rod
Release Material Sheet
3. Holding the bottom of the realease material sheet in place,
gently pull the sheet toward the front of the platen.
NOTE: Make sure release material fits smoothly over upper
platen.
4. Place locking clips over release material sheet and press
into place over release material bar
5. Check alignment and tightness of release material against
upper platen.
NOTE: Installing release material sheets too tight may cause
premature failure of the sheet.
Installing only 1 clip on over the release material bar
may cause the release material sheet to be too loose.
Ensure that 2 clips are installed on the tefl on bar at
all times.
Relase material sheets should be replaced when:
•
Product sticks to release material
• Carbon build-up causes problems in taste or
appearance.
•
A tear in the release material sheet’s cooking area.
•
Relase material coating is worn off sheet.
NOTE: Rotate the release sheets on daily basis
RELEASE MATERIAL INSTALLATION
Summary of Contents for MWE-9501
