![background image](http://html1.mh-extra.com/html/garland/mwe-9501/mwe-9501_operation-manual_564375021.webp)
Standby Mode:
EXIT the Standby Mode:
1. SELECT a clam grill menu by pressing the "MENU
SELECT" button, until you attain the required menu
item.
NOTE: If the display reads either "TOO COOL" or "TOO
HOT" the upper platen will not go into "STANDBY".
2. PRESS the GREEN ("CANCEL/RAISE") and the BLACK
("STANDBY") buttons at the same time. As soon as the
upper platen moves down, release both buttons and press
the BLACK ("STANDBY") button again, (within 5
seconds), from the start of a cook cycle,the display will
read "STANDBY MODE" alternating with the "MENU
ITEM".
1. PRESS the GREEN ("CANCEL/RAISE") button.
The upper platen will raise and the display will read
"CANCEL" with an audible alarm.
4. When the cooking time has been completed, the display
will flash "REMOVE" with an audible alert. Remove
product per the prescribed method.
NOTE: If a required flat grill menu cannot be found, go
to the programming mode (see programming, "MENU
ITEMS".
1. PRESS the "TEMP" button and repeat for each zone to be
displayed.
1st press - CENTER UPPER PLATEN
2nd press - REAR LOWER ZONE
3rd press - CENTER LOWER ZONE
4th press - FRONT LOWER ZONE
NOTE: The temperatures may be displayed at any time,
including during a cooking cycle.
To display all temperature zones at the same time, press the
"TEMP" button one, (1), time, then the "PROG" button five,
(5), times.
To View Settings for a Menu Item:
To Display the Current Temperature
Standby Alarm (Version 6.20 and higher)
An audible alarm called the "Standby Alarm" has been added
to version 6.20 EPROM chip. This alarm, when enabled to
"YES" (See Programming - System Setup) will sound if the
grill has been idle for 300 seconds (5 minutes) signaling the
operator to put the grill into the Standby Mode.
The alarm is INACTIVE if the "Standby Alarm" feature
under SYSTEM SETUP is enabled to "NO".
1. With the required menu displayed, PRESS the "UP
ARROW " button ( ( ).
2. PRESSING the "UP ARROW" button ( ( ) repeatedly will
cycle through and display that menu's function time(s),
set temperature(s) and the gap setting (if applicable).
NOTE: The display will return to the menu (menu name)
after five (5) seconds if the "UP ARROW" button ( ( ) has
not been pressed.
To Reset Factory Defaults
NOTE: All settings on all menus will revert to factory
defaults. It is recommended that all current settings be
recorded on paper prior to reloading the factory default
settings.
1. PRESS and HOLD the "PROG" button for five, (5),
seconds. (Display will flash GC450 and the program
version number.
2. PRESS and HOLD the "UP ARROW" button ( ( ) for
twenty, (10), seconds, "RELOAD DEFAULTS " will be
displayed.
3. PRESS the "RIGHT ARROW" button (®) to reload.
(Display will read "RELOADING DEFAULTS").
4. PRESS the "RIGHT ARROW" (®) to return to the normal
OPERATING MODE.
NOTE: Pressing any other button will cancel the RELOAD
DEFAULTS request.
NORMAL OPERATING MODES
Summary of Contents for MWE-9501
