![background image](http://html1.mh-extra.com/html/gardner-denver/governor-ten014983/governor-ten014983_user-manual_3581592074.webp)
13-17-621 Page 74
4.4 Sequencing
The Gardner Denver Governor™ controller is capable of communicating with several different generations
of Gardner Denver controls to allow multi-machine sequencing of new and existing Gardner Denver
equipment. Depending on the protocol selected, up to 4 or 8 machines may be sequenced on a single
installation without the use of a master controller.
Table 34 below shows the settings available under the
Sequencing
menu
.
Click on the desired setting from
the Sub-Menu column to directly jump to the respective setting.
For more comprehensive and detailed information on sequencing of machines, refer to the
Governor
Sequencing Manual
, document number
13-17-625
.
Table 34: Sequencing Settings
Sequencing Settings
Setting
Sub-Menu
Short Description
Sequencing
Gives Information about the different Sequencing Types
Summary of AirSmart Protocol Sequencing Settings
Summary of Delcos Protocol Sequencing Settings
4.4.1 Sequencing Types:
Figure 100 outlines the
Sequencing
settings home screen for the
ES+
protocol. This screen will list different
settings depending on the sequencing protocol that was selected on the communications screen, refer to
Figure 93 above for the different sequencing types available.
As you can see the
Sequencing Type
selection setting is
disabled
on this screen. If you touch
Sequencing
Type
, a pop
up message will come up saying it can’t be configured here and will show the path where it
can be found, shown in Figure 101 below.
Figure 100: ES+ Protocol Sequencing Settings