![background image](http://html1.mh-extra.com/html/gardner-denver/electra-saver-g2/electra-saver-g2_operating-and-service-manual_3874922025.webp)
13-21-611 Page 24
3-3
The compressor starts and stops automatically. Automatic restarting can cause
injury or death. Open, lockout and tagout main disconnect and any other circuits
before servicing the unit.
STARTING THE UNIT
- Observe the following starting procedures.
Unit Cold
- If the unit is a water-cooled heat exchanger model, open any manual water inlet valves wide
open. Start the unit by pressing RUN. Since the unit is equipped with a minimum (65 psig, 4.5 bar) pressure
discharge valve, no special procedure to maintain unit reservoir pressure is required.
Unit Hot
- No warm-up period is required. If the unit is a water-cooled heat exchanger model, open any
manual water inlet valves wide open. Start the unit by pushing RUN
DAILY CHECK
-
Refer to Section 8, “Maintenance Schedule,” page 92.
STOPPING THE UNIT
- Press the STOP button. The oil reservoir will automatically blow down as the
motor stops. If the unit is a water-cooled heat exchanger type, close any manual water inlet valves.
Summary of Contents for ELECTRA-SAVER G2
