![background image](http://html1.mh-extra.com/html/gardner-denver/electra-saver-eayq-e/electra-saver-eayq-e_operating-and-service-manual_563785066.webp)
13–10–613 SP Page 57
SYMPTOM
POSSIBLE CAUSE
REMEDY
Oil Carry–Over (Continued)
2.
Clogged, broken or loose
2.
Tighten or replace faulty
oil return lines
lines.
3.
Ruptured oil separator
3.
Replace element.
element.
4.
Loose assembly.
4.
Tighten all fittings and
gaskets.
5.
Foam caused by use of
5.
Use Gardner Denver
R
incorrect oil.
AEON
t
9000 SP
Lubricating Coolant.
6.
Inoperative minimum
6.
Clean out or replace valve.
pressure valve, causing low
operating pressure.
7.
Operation at elevated
7.
Reduce temperature. See
discharge temperatures.
High Discharge Air
Temperature, page 56,
this section.
8.
Scavenge line check
8.
Replace check valve.
valve failure.
9.
Water condensate in oil.
9.
Check oil reservoir tempera–
ture and if low, change
thermal mixing valve element
to higher temperature.
Gardner Denver factory remanufactured replacement compressor air end units
are available from your authorized distributor, on an exchange basis, for all rotary
screw compressor units.
Summary of Contents for ELECTRA-SAVER EAYQ E
