33
32
GB
IRE
MODEL: GLBC 43
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
NOTE!
Store the equipment in a dry place and far away from possible ignition sources
such as an oven, a gas-fired hot water boiler, a gas-fired dryer, etc.
Putting the equipment back into operation
1
Remove the spark plug (see 8.3).
2
Quickly tug on the starter line to remove excess oil from the combustion chamber.
3
Clean the spark plug and check that the electrode gap is correct, or insert a new
spark plug with the correct electrode gap.
4
Prepare the equipment for operation.
5
Fill the tank with the relevant mixture of fuel and oil. See the section 'Fuel and oil'
on page 18.
Transport
To transport the equipment, empty the petrol tank as described in the section
'Storage' on page 31. Clean coarse dirt off the equipment with a brush or hand
brush. Dismantle the steady grip and the long hande as described under the
section 'Before starting the equipment' on page 12.
Cleaning
Always switch off the equipment and disconnect the spark plug boot before
carrying out any cleaning work.
•
The equipment should be cleaned thoroughly every time after it has been used.
This applies particularly to the cutting tool and the guard hoods.
•
Keep the air vents and the motor housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it down with compressed air at
low pressure.
•
It is easiest to remove dirt and grass immediately after use.
•
Clean the equipment regularly with a damp cloth and some soft soap. Do not use
cleaning agents or solvents; these may be aggressive to the plastic parts in the
equipment. Ensure that no water can get into the interior of the equipment.
Useful Information
6