16
Assembly and Parts List
3
5
Fitting the cutting line guard hood on the cutting blade guard hood
IMPORTANT!
The cutting blade guard hood (Fig.7b/Item 15) must be fitted when you want
to work with the cutting blade.
•
The guard hood for the cutting line must be installed as shown in Figures
7a-7b. Make sure that the cutting line guard hood engages correctly.
A blade (Fig. 7a/Item F) on the underside of the guard hood automatically cuts
the cutting line to the optimum length. It is covered by a guard (Fig. 7a/Item G).
Remove the cutting line guard (G) before you start working and replace it
when you have finished working.
6
Fitting/Replacing the line spool
The procedure for fitting the line spool (13) is shown in Figure 7c. To dismantle,
proceed in reverse order. The line spool is already fitted when the equipment
is delivered.
IMPORTANT!
Left-hand thread (i.e. Turn the spool clockwise to undo / release)
Fig 7d, shows the semi-circular cut-out (U), in the rim of the gearbox end with
the splined shaft, and also the the round hole (V) in the dished metal guard plate.
The alignment of these is fixed.
Fig 7e, shows the Brass coloured carrier plate (22) with a splined hole, fitted to
the splined shaft. This then rotates with the spindle, which has a threaded end.
There is a hole (W) in the side of the carrier plate (22), and this has to be rotated
with the spindle, to align with the other 2 holes.
Look through this hole, and rotate the spool / spindle until all 3 locations are
aligned, then fit the small 4mm hexagon key (29) through all 3 locations, thus
locking the spindle, so the thread of the spool can be tightened / released.
(See Fig. 7c.)
GB
IRE
MODEL: GLBC 43
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
