28
Instructions
5
GB
IRE
MODEL: GLBC 43
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
Replacing the line spool/cutting line
1
Dismantle the line spool (13) as described under 'Fitting/Replacing the line spool'
on page 16. Press the spool together (Fig. 12a) and remove one half of the
housing (Fig. 12b).
2
Take the spool plate (K) out of the line spool housing (Fig. 12c).
3
Remove any remaining cutting line.
4
Place the new cutting line in the center and hang the loop which has formed
into the recess in the spool splitter (Fig. 12d).
5
Wind up the line counter-clockwise and under tension. The spool splitter will
separate the two halves of the line (Fig. 12e).
6
Hook the last 15 cm of the two ends of the line onto the opposite line holders
of the spool plate (Fig. 12f).
7
Thread the two ends of the line through the metal eyelets in the line spool
housing (Fig. 12c).
8
Press the spool plate into the line spool housing (Fig. 12b).
9
Pull the two line ends sharply to release them from the line holders.
10
Join the housing parts together again.
11
Cut the excess line to a length of around 13 cm. This will reduce the load
on the engine when starting and warming up.
12
Refit the line spool (as described under 'Fitting/Replacing the line spool'
on page 16). If you are replacing the complete line spool, skip points 3-6.
Fig. 12a
Fig. 12b
