30
Instructions
5
GB
IRE
MODEL: GLBC 43
AFTER SALES SUPPORT
0151 649 1500
1890 946244
www.einhell.co.uk
Fig. 13a
Fig. 13b
Setting the throttle cable
If the maximum speed of the equipment drops over time and you have ruled out
all the other possible causes listed in the section 'Troubleshooting' on page 33,
it may be necessary to adjust the throttle cable.
First of all check whether the carburettor opens fully when the throttle lever is
pressed right through. This is correct if the carburettor slide (Fig. 13a/Item F)
is completely opened when the throttle is fully activated.
Figure 13a shows the correct setting. If the carburettor slide is not completely
open, it must be adjusted.
The following steps are required to adjust the throttle cable:
•
Undo the lock nut (Fig. 13b/Item C) a few turns.
•
Undo the adjusting screw (Fig. 13b/Item D) until the carburettor slide is
completely open when the throttle is fully activated, as shown in Figure 13a.
•
Retighten the lock nut.
Setting the idling speed
CAUTION!
Set the idling speed when the equipment is warm. If the engine stalls when
the throttle is not pressed and you have ruled out all the other possible causes
listed in the section 'Troubleshooting' on page 33, the idling speed must be
adjusted. To do this turn the idling speed screw (Fig. 13b Item E) clockwise
until the equipment runs smoothly at idling speed.
If the idling speed is so fast that the cutting tool turns as well, it has to be
reduced by turning the idling speed screw for as far as is required for the
cutting tool to stop rotating.