GARANT XCONTROL, User Manual

Page: 57 / 292

de
bg
da
en
fi
fr
it
hr
lt
nl
no
pl
pt
ro
sv
sk
sl
es
cs
hu
7 ;=================================
8 ; M19 / M20 SPINDLE ORIENTATION
9 Q1913 = 19
10 ;=================================
11 CALL PGM TNC:\X_CONTROL\L_LENGTH.H
12 END PGM BSP_L_LENGTH MM
Back to Heidenhain automatic operation [ } Page 53]
7.4.4. Auxiliary cycle L_START
Probe cycle Function Note Program code
L_START XControl switches to standby
mode after 10 minutes without
measurement. Reactivation of
wireless connection is automatic
upon call-up of a probe cycle,
but takes approx. 15 seconds.
Auxiliary cycle L_START can be
used to manually reactivate the
wireless connection, in order to
reduce non-productive times. L_START
Example/program code: CALL PGM TNC:\X_CONTROL\L_START_XC1.H ;
T1234 Change tool.
⁝ NC program
⁝ Tool positioning 5 mm above the XControl.
Back to Heidenhain automatic operation [ } Page 53]
7.4.5. Auxiliary cycle L_RESET
Probe cycle Function Note Program code
L_RESET After 100 probe processes, the
wireless connection is deactiv-
ated. The reactivation of the
wireless connection is automatic
upon call-up of a probe cycle,
but takes approx. 15 seconds.
Through call-up of the auxiliary
cycle, the counter of the meas-
urements is reset and the wire-
less connection is maintained. L_RESET
Example/program code: CALL PGM TNC:\X_CONTROL\L_RESET_XC.H ;
Back to Heidenhain automatic operation [ } Page 53]
8. Error messages
Error code Fault Possible cause Action Performed by
#1010 WIRELESS SIGNAL
MISSING Wireless connection
between the stick and
the probe device can-
not be established. Carry out reset.
Check whether measur-
ing device is within
wireless range.
Reconnect USB stick.
Trained specialist for
mechanical work
www.hoffmann-group.com
57