Galvanic Applied Sciences 943-TGX-CE, Operation Manual

Page: 61 / 151

Revision 4 61 April 2020
4.8 Configuration (Config) Panel
The Configuration panel is used to configure a broad range of analyzer operating parameters.
It has a total of 5 sub-panels, each of which is used to configure a certain type of operating
parameters. To change from one sub-panel to the next, press the F2 or F1 keys on the keypad.
Note that pressing F2 from the right most sub-panel (Network) will return to the Analysis 1 tab,
and pressing F1 from the left-most sub-panel (Outputs) will go back to the Absorbance panel.
Unauthorized modification of the values of many of the parameters available in the
Config panel could result in the analyzer becoming unable to function correctly. The
parameters on this panel should ONLY be changed by factory-trained personnel or
under the direction of Galvanic Applied Sciences Inc.
4.8.1 Outputs
The Outputs sub-panel shown in Figure 37 is used to configure the four analyzer analog
outputs.
Figure 37: Outputs Sub-Panel
There is a total of four analog outputs that can be set up. To access a specific analog output,
use the F4 / F3 keys to highlight the
Select Analog Output: button, then press
↵
to move to
the next analog output. When on Analog Output 4, pressing this button again will move back
to Analog Output 1.
The configuration options available for all four analog outputs are identical. The output
parameters available are listed in Table 12.