A
B
C
C
B
A
A
B
C
A
Premium Unleaded / 98
B
Diesel
C
Unleaded
Tee connector
3/4” Ball valve
3/4 - 3/4” BSP elbow
•
Plug or cover the pipe delivery ducts to stop any foreign matter entering the sump box.
•
Install the main product feed lines into the sump, according to the following figure.
Figure 4.
Main Product Feed Line Configuration
• Install the feed line within the sump. The picture below shows the typical feed line
assembly. It considers the use of a Tee connector terminated with a ¾” ball valve and a
¾ - ¾” BSP Elbow. These components are not supplied by Gallagher Fuel Systems.
Note:
Inside distance between bulkhead seals in hydraulic enclosure is 432mm, therefore
the feed line Tee termination arrangement must fit within this distance. Ensure the ball valve
faces toward the bottom of the sump, no more than 10 degrees off vertical and with the lever
side towards the column.
Figure 5.
Typical Feed Line Assembly
9
APOLLO 3000L INSTALLATION
2A03229 APOLLO 3000L Installation and Commissioning Manual Issue 1
