ADP 4100 Printer
Jam at Print Head
: Stock did not pass over the print head at the expect point or time in the print process.
Press RESET key to clear jam, and then the ONLINE key to place the unit back in operation.
J a m – P r i n t
C l e a r , P r e s s R e s e t
O f f l i n e
P r e s s E n t e r f o r M e n
Load Error at Bin A
: Stock is detected at input, but the unit was unable to pull stock into the transport
mechanism from Bin A.
Removing stock completely from Bin A and reinserting should clear the error. Pressing the ONLINE key
should place the unit back in operation. Messages may vary slightly depending on the sequence of
events.
B i n A L o a d E r r o r
R e m o v e & R e l o a d
B i n ( s ) A E m p t y
P l e a s e L o a d S t o c k
Load Error at Bin B
: Stock is detected at input, but the unit was unable to pull stock into the transport
mechanism from Bin B.
Removing stock completely from Bin B and reinserting should clear the error. Pressing the ONLINE key
should place the unit back in operation. Messages may vary slightly depending on the sequence of
events.
B i n B L o a d E r r o r
R e m o v e & R e l o a d
B i n ( s ) B E m p t y
P l e a s e L o a d S t o c k
Load Error at Bin C
: Stock is detected at input, but the unit was unable to pull stock into the transport
mechanism from Bin C.
Removing stock completely from Bin C and reinserting should clear the error. Pressing the ONLINE key
should place the unit back in operation. Messages may vary slightly depending on the sequence of
events.
B i n C L o a d E r r o r
R e m o v e & R e l o a d
B i n ( s ) C E m p t y
P l e a s e L o a d S t o c k
Jam at Burster
: Stock was not properly separated at the perforation by the burster module.
Manually back the stock out of the unit using the Encode and Bin path knurl knobs. Press RESET key
and reload stock, then press the ONLINE key to place the unit back in operation.
J a m – B u r s t F a i l
C l e a r , P r e s s R e s e t
O f f l i n e
P r e s s E n t e r f o r M e n
42
ADP 4100 Printer
Installation and Operators Manual
, April 2007
