GALA SYNERGIC 5000
17
3.7. WELDING MODE BY MEANS OF USER PROGRAMMES (JOB).
10 user-customised welding programs can be recorded with the JOB mode, which can be reproduced at
any time.
3.7.1 USER PROGRAM RECORDING.
A welding program can be recorded from a manual welding program or from a synergic welding
program.
RECORDING OF A MANUAL WELDING PROGRAM (See section 3.5).
Firstly select the working mode (continuous, spot or intermittent) and pulse mode (2S/4S);
1- Select MANUAL program from welding mode.
2- Adjust the desired welding voltage and wire speed for the welding program to be recorded.
D1
P1
)
D2
P7
P2
LD25
3- Press JOB pushbutton (P7) for 2 sec, the LD25
led starts to flash.
4- The JOB program no. consecutive to the last one
recorded flashes on and off on the display D2, (Job
XX); with pushbuttons P1 and P2 we can assign a
different program no. to the one suggested. If a
program no. that already exists should be selected
during the recording process the latter will be deleted
and the new one recorded. The welding voltage
regulation made for the recording will be indicated on
display D1 (selector switch position, E.g. A-7).
5- After selecting the program no. briefly press the
JOB pushbutton, the JOB led (LD25) will stop flashing
and will light up continuously; the program has been
recorded.
6-When LED LD25 lights up this tells us that we are
in JOB mode, the program no. will correspond to the
one previously recorded. Under these conditions we
can enter the parameter setting mode and personalise
the variables that we wish for this JOB (see section
3.6).
RECORDING OF A SYNERGIC WELDING PROGRAM (See section 3.4).
Firstly select the working mode (continuous, spot or intermittent) and the pulse mode (2S/4S);
1- From welding mode select the desired synergic program and the wire diameter to be used.
2- Set the desired welding power for the welding program to be recorded.
3- Press JOB pushbutton (P7) for 2 sec; the LD 25 led starts to flash.
4- The JOB program no. consecutive to the last one recorded flashes on and off on the display D2, (Job
XX); with pushbuttons P1 and P2 we can assign a different program no. to the one suggested. If a program
no. that already exists should be selected during the recording process the latter will be deleted and the new
one recorded. The welding voltage regulation made for the recording will be indicated on display D1 (selector
switch position, E.g. A-7).
5- After selecting the program no. briefly press the JOB pushbutton, the JOB led (LD25) will stop flashing
and will light up continuously; the program has been recorded.
6-When LED LD25 lights up this tells us that we are in JOB mode, the program no. will correspond to the
one previously recorded. Under these conditions we can enter the parameter setting mode and personalise
the variables that we wish for this JOB (see section 3.6).