GALA SYNERGIC 5000
14
3.5. WELDING MODE BY MEANS OF MANUAL PROGRAM.
This program enables the parameters to be adjusted manually just like any traditional machine. Firstly,
before proceeding to select the manual program you must define the working mode (continuous welding, spot
or intermittent welding) and the pulse mode on the torch pushbutton:
P4
P5
LD20
LD21
LD18
LD19
1st. By means of P4 pushbutton we selected:
LD18/LD19 off: Continuous welding.
LD18 on: Spot welding.
LD19 on: Intermittent (intervals) welding.
2nd: By means of P5 pushbutton we selected:
LD20 on: 2S
(It is necessary to press the pushbutton to
weld).
LD21 on: 4S
(It is not necessary to press the pushbutton to
weld).
Once the working mode has been defined, you must carry out the following process:
1
st
. DETERMINE THE MANUAL WELDING PROGRAM.
LD1-LD6
P1
"
1
st
. By means of P1 we will select MANUAL program
(LED LD1 comes on).
2
nd
. SELECT THE WIRE SPEED AS INDICATIVE VARIABLE.
D2
D1
LD11
P3
)
2
nd
. By means of P3 we will select the wire speed as
indicative variable (m/min), LED LD11 will come on.
Display D1: It will indicate the real welding voltage.
Display D2: It will indicate the regulated wire speed,
will automatically stop to indicate the welding current
at the moment that begins the process.
3
rd
. REGULATE THE WIRE SPEED AND THE WELDING VOLTAGE.
4
m/min
10
16
7
13
19
1
V
U
Adjust the wire speed with the wire-feed
potentiometer. The outer dial identifies the manual
speed regulated (1-19 m/min), you can read the
specific speed set on display D1.
By means of controls V and U you will be able to
regulate the welding voltage;
V: 3 adjustment ranges.
U: 10 positions incremental range.
