© 2012 G Force Automatic Gates All Rights Reserved
Internal Manual Release
AG5 DC2 GATE MOTOR
INSTALLATION AND SET UP
INSTRUCTIONS
Internal Release
Plate
Engaged
Drive Arm
Remove the motor cover. Use two 13 mm spanner to loosen the manual release nut and bolt.
Push the DC motor away from the gears to disengage the motor and allow the gate drive arm
to move by hand.
Pull the DC motor back towards the gears to engage. Ensure the DC motor gear has
meshed
with the drive gear. Fully tighten the Internal Release Bolt and check the gears are engaged.
External Manual Release
Swing Arm
Drive Arm
Swing Arm
Use a 19 mm spanner to undo the two bolts. Fold
the swing arm back and tie up to the bottom of
the gate. Screw the two bolts back into the Drive
Arm.
Internal Release
Bolt
Engaged
Internal Release
Bolt
Disengaged
Internal Release
Plate
Disengaged
DC Motor
